g00eY wrote: I think getting my head forward and up is something I can work whilst doing running plants and other drills. ...
I seem to remember you doing a run/plant drill between 2 cones and although you didn't jump off the ground (by intent, as it wasn't what you were drilling on), you did a bit of a "fake" chest drive and threw your head UP. It was one of your vids from awhile ago ... not recently. That's the wrong behavior. That's an UNNATURAL head motion. Really, I would not do ANYTHING, since the more you focus on what your head is doing, the more you're going to feel compelled to do SOMETHING. Just relax!

g00eY wrote: Kirk, when you say I'm bending my trail leg too much, which jumps are you talking about? ... I don't have that huge cock in the trail leg that TylerPorter11 has, but in my C position there's a little bending too.
I saw it in your last jump, and I double-checked, and it looks like it's there. In the frame just before you go behind the guy in the orange T, your entire body is contrasted against the white wall. It's quite blurry, but it sure looks like your trail leg knee is at 90 degrees. That's at the Whip point ... the end of your downswing (roughly).
To improve the quality of your vids, you might want to bring the camera in a little closer ... and get all your fans to stand on the other side of the runway!

g00eY wrote: I typically spend most of my "weight room" time working on the high bar doing the whip/hinge drills.

Make sure your trail leg is straight until you pass thru the Whip point (directly under the bar). And make sure you start it out being straight ... or at least FAIRLY straight (like Amy is OK
for this drill ... but maybe not quite as much bend as her). If you haven't seen Amy's rings drill, search for "Amy rings".
Kirk